Our 2 tonne
system fully extends
in under
6 seconds
- Our 2 tonne light-vehicle jack is the perfect solution for any high-volume inspection lane
- Air-assisted cylinders for fast jacking of small vehicles.
- Balance valve gives even lifting under offset load
- Max lift height 350mm
- Adjustable contact points
- 3-phase, 10A electrical supply required
- Upgradeable to other load ratings if required
- Various adapters and extension pieces are also available so that a wide range of vehicle axle types and combination’s can be securely lifted
Our Jacking Systems provide speed, reliability and safety. They are simple to use, inherently safe and solidly built with pride in manufacture and appearance.
We offer a full service which includes Jacking Systems, pit rail manufacture and installation on site anywhere in New Zealand. Existing pit rails can be modified by one of our engineers to accommodate our jacking systems or we can design our Jack to suit your rail requirements if possible.
Our nationwide backup service is second to none.
We believe our Jacking Systems are the best on the market. With quality components and a solidly built chassis they are made to last.
International Orders:
Regardless of your location our systems can be wired to run to your country’s standard. Each jacking system will be tested and bled before being freighted to its destination. Installation kit and instructions will be supplied with every system. Upon arrival, our International service agent will commission your system on site to ensure everything is operational (included in purchase price).
Pit Requirements:
— 3 phase-neutral and earth-5 core 1.5mm wiring to power our systems with a 20 amp fuse installed.
We need to know:
— The profile of your pit rails
— The length of your pit
— The width of your pit
-
2-Tonne system
Pneumatic 2-tonne System. *Note: Catenary wire on each side of pit which allows free travel of the air coil and electrical cabling.
-
Engineered to last
"The quality will remain when the price is long forgotten" - Henry Royce
-
2-Tonne system in use
Pneumatic 2-tonner hard at work with lifting adapters being used for a stable lift.
-
2-Tonne system extended
Pneumatic 2-tonne System with lifting beam and outriggers extended.
-
Full control
System controls are easy to use.
-
10-Tonne system detail
Shown retracted with two diff adapter options.
